Simulation Demonstrates Impact Of Current-Loop Crossover Frequency On Stability
by Christophe Basso, ON Semiconductor, Toulouse, France, How2Power Today, Jan 15 2021
Focus:
For switching converters operating in current-mode control, many engineers mistakenly
believe that the subharmonic oscillations that occur at half the switching frequency in
the voltage loop are caused by a peak in the current loop response at this frequency. In
reality, the instability observed as a peak in the voltage loop at Fsw/2 is simply due to
a poor phase margin in the current loop (caused by a pair of right-half plain zeros) not
because of a peak there. While this phenomenon was analyzed and explained many years ago
through modeling of current-mode control, it can be difficult to find experimental results
that demonstrate the underlying relationships between power supply crossover frequency,
phase margin and the resulting instability. This 24-page article presents circuit models
in SPICE and SIMPLIS that engineers can use to simulate these effects.
What you’ll learn:
- How to simulate the relationships between crossover frequency, phase margin and stability in current-mode controlled power converters
- How to predict subharmonic oscillations in a current-mode controlled converter using SPICE and SIMPLIS simulations
View this Source (requires a PDF Viewer installed on your device)
© 2025 How2Power. All rights reserved.